CUBOFIX HEAT INSULATION BOARD MORTAR

DESCRIPTION

Cement based, single compenant, polymer and fiber added, high preformance, flexible, its produced for heat insulation boards (EPS, XPS and Rockwool) a plaster mortar which has ultra adhesion ability. There are two colour options; White and grey.

APPLICATION AREAS

In interior and exterior areas, it is used for a mesh plaster application over heat insulation boards (EPS,XPS and Rockwool). Its durable to water.Easy to apply, perfect adhesion to surface.Flexible and it provides high stability, it does not sag or crack.It has a high level of water vapor permeability, it provides breathing of surface.

PREPARING THE SURFACE

The surfaces which will applied, should be purged from any kind of materials which will prevent the adhesion and sturdy. The cavities between boards must be filled with the same material or foam. Fixing plug application and the assembly of the building corner profiles, the window and door connections should have been finished.

APPLICATION

25 Kg CUBOFIX AAC ADHESIVE MORTAR is added into 6-7 Lt. clean water and it is mixed as will not remain any lump inside of its, by the help of slow speed mixer.. The prepared mortar, is applied by mixing it again after rested 5-10 min. and should be consumed in 2 hours. The prepared plaster mortar, is applied over the boards which finished assembly, as 8 or 10 mm thickness with toothed trowel. While the mortar which applied to the surface, is damp, the mesh is embedded inside of the mortar by stretching from the top towards the bottom. The plaster application should be 3 mm thickness and the plaster mortar below the mesh should be min. 2 mm. If the mesh stays at the bottom, the mesh that used for the surface tension, can not do its duty.The surface must be moisturized on hot and windy weathers.Ambient temperature should be in the range of +5°C through +35°C. Avoid of application on flexible and wet surfaces. Do not use by adding water or mortar to frozen material.

CONSUMPTION

An area 3-5m² can be applied with 1 Kg CUBOFIX HEAT INSULATION BOARD PLASTER.

STORAGE CONDITIONS

Must be stored on the pallet, dry and cool place in 10 layer stacks maximum. The life time of the unopened original package is one year. After unpacking, it should be consumed in 7 days.

DANGER & SECURITY INSTRUCTIONS

R 36/38 - Irritating to eyes and skin.

R 43 - May cause sensitisation by skin contact.

S 2 - Keep out of the reach of children

S 25 - Avoid contact with eyes

S 26 - In case of contact with eyes, rinse immediately with plenty of water and seek medical advice

S 29 - Do not empty into drains

S 64 - If swallowed, rinse mouth with water (only if the person is conscious)

Online

CATALOUGE

We create joyful places in all life spaces

by presenting solutions from inner to outer and from base towards ceiling.

CUBO IS A BASERGUN A.Ş. GROUP COMPANY © 2018.