CUBOFIX HEAT INSULATION BOARD ADHESIVE MORTAR

DESCRIPTION

Cement based, single compenant, polymer and fiber added, high preformance, flexible, its produced for heat insulation boards (EPS, XPS and Rockwool) an adhesive mortar which has ultra adhesion ability. There are two colour options; White and grey.

APPLICATION AREAS

In interior and exterior areas, it is it is applied to the adhesion of the heat insulation boards (EPS,XPS and Rockwool) to surfaces of brick, plaster and concrete. Its durable to water.Easy to apply, perfect adhesion to surface.Flexible and it provides high stability, it does not sag or crack.It has a high level of water vapor permeability, it provides breathing of surface.

PREPARING THE SURFACE

The surfaces which will applied, should be purged from any kind of materials which will prevent the adhesion and sturdy. The surfaces which are painted or blistered, must be scraped and cleaned.The cavities and cracks must be repaired with the CUBOFIX repair mortars. The application surface should be moisturized on windy and hot weathers.

APPLICATION

25 Kg CUBOFIX HEAT INSULATION BOARD ADHESIVE MORTAR is added into 6-7 Lt. clean water and it is mixed as will not remain any lump inside of its, by the help of slow speed mixer. The prepared mortar, is applied by mixing it again after rested 5-10 min. and should be consumed in 2 hours.According to the surface that will be applied to;

1. Adhesion to whole surface.

The prepared CUBOFIX HEAT INSULATION BOARD ADHESIVE MORTAR, is applied as there will be 1 cm gaps at the edge of the insulation boards with toothed trowel, to the whole surface.

2. Adhesion by frame method .

The prepared CUBOFIX HEAT INSULATION BOARD ADHESIVE MORTAR, is applied to the edges of the insulation boards as frame style and is put 1 or 2 point to its center. Both of methods the insulation boards are adhered by press to the surface and passed to fixing plug installation after it finishes drying (min. 24 hours) The most important case during the fixing plug installation is, adhesive mortar should be have behind of the fixing plug. Ambient temperature should be in the range of +5°C through +35°C. Avoid of application on flexible and wet surfaces. Do not use by adding water or mortar to frozen material.

CONSUMPTION

An area 4-5m² can be applied with 1 Kg CUBOFIX HEAT INSULATION BOARD ADHESIVE MORTAR.

STORAGE CONDITIONS

Must be stored on the pallet, dry and cool place in 10 layer stacks maximum. The life time of the unopened original package is one year. After unpacking, it should be consumed in 7 days.

DANGER & SECURITY INSTRUCTIONS

R 36/38 - Irritating to eyes and skin.

R 43 - May cause sensitisation by skin contact.

S 2 - Keep out of the reach of children

S 25 - Avoid contact with eyes

S 26 - In case of contact with eyes, rinse immediately with plenty of water and seek medical advice

S 29 - Do not empty into drains

S 64 - If swallowed, rinse mouth with water (only if the person is conscious)

Online

CATALOUGE

We create joyful places in all life spaces

by presenting solutions from inner to outer and from base towards ceiling.

CUBO IS A BASERGUN A.Ş. GROUP COMPANY © 2018.